Commercial Aircraft Structures
March 22, 2022Removing Rivets in the 90 Degree Drilling Project
March 22, 2022
Before holes are drilled in an assembly, their locations must be marked.
By the end of this course, you will be able to
• Recognize fastener location and identification information on an engineering drawing
• Explain where to find the tools, fasteners, and other supplies needed to create an
assembly
• Prepare the surface of an assembly for mark up
• Properly measure and mark corner fastener locations
• Calculate fastener locations using information given on the engineering drawing
• Mark fastener locations using the calculated fastener location information
Course ID Number: AER-4001